Mechanical Products
Results Found: 6

CAD_Mech_Off

Lubricants: GRINNELL Gasket Lubricants

During installation of a GRINNELL Coupling, always lubricate the gasket. For couplings using the tri-seal gasket in a low temperature application, use a petroleum-free silicone based lubricant. For mechanical tees and straps when used in low temperature applications, use a petroleum-free silicone based lubricant, otherwise no lubricant is required.

Data Sheet: G610

Gaskets-C: "C" Style Replacement Gaskets

The standard style gasket, with a "C" shape configuration, is the most commonly used. It is provided as the standard gasket in the Figure 705, 707, 770, 772, 780, 405, and 472 GRINNELL Couplings. The gasket is available in Grade "E" and "EN" EPDM, Grade "T" Nitrile, Grade "L" Silicone, and Grade "O" Fluoroelastomer.

Data Sheet: G610

Gaskets-Tri: Tri-Seal Replacement Gaskets

The tri-seal gasket is designed to close off the gap or gasket cavity. This is accomplished by positioning the centre "rib" of the gasket over the gap between the pipes. The tri-seal gasket has two tapered sealing edges in addition to the centre rib for additional strength and sealing. The Tri-Seal gasket can be used with the Figure 705, 707, 770, 772, 405, and 472 GRINNELL Couplings.

Data Sheet: G610

Gaskets-71: Flange Adapter Replacement Gaskets

This gasket is specifically designed for use with the Figure 71 Flange Adapter. The gasket has an optimum amount of rubber to provide a dependable seal between both the pipe and mating surface. The gasket is available in Grade "E" EPDM and Grade "T" Nitrile.

Data Sheet: G610

Gaskets-716: Reducing Coupling Replacement Gaskets

The reducing gasket is provided with ribs used to position the larger pipe so that the sealing lip is located on the sealing surface of the pipe. This gasket is used only with the Figure 716 GRINNELL Reducing Coupling and is available in Grade "E" EPDM and Grade "T" Nitrile.

Data Sheet: G610

Gaskets-730: Outlet Fitting Replacement Gaskets

The gasket provides a compression type seal, which is designed to conform to the exterior curve (OD) of the pipe. This design is unique to the Figure 730 Mechanical Tee (threaded and grooved).

Data Sheet: G610